Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Get your free estimateGarage Door Company in Glendale, CA
Garage door installation in Glendale usually runs $700 – $2,200 depending on the door, the opening size, and what’s involved in the swap. We’re Stonewall Garage Door Repair, and we’ve served Glendale since 2013. The homes here – Spanish bungalows from the 1920s, mid-century ranches up the Verdugo slopes, newer builds near the 2 freeway – each throw their own curveballs at an installer, and we’ve learned to read them fast. Call (855) 740-8388 when you want a straight answer about your door.
Why Glendale Homes Are Different
Glendale’s housing stock runs from 1920s Spanish Colonial and Tudor bungalows in the flatlands around 91201, 91203, and 91205 to 1960s and 70s ranch and split-level homes climbing the hill ZIPs. A lot of those older detached garages were added after the original build, which means things like undersized openings, shifted framing, and torsion spring setups that predate modern safety standards. An installer who measures for a stock door off a big-box shelf is going to run into problems. The floor pitches, the header’s off by half an inch, the side clearance isn’t there. We’ve seen it all across 91207 and 91208especially.
Then there’s the terrain. In the canyon areas off Glenoaks and up toward Chevy Chase Canyon, garage floors pitch more than most people realize. A door that looks fine when it’s closed binds at mid-travel because the tracks want the floor to be level and the floor isn’t cooperating. Slope-specific shimming isn’t a specialty call for us here – it’s a regular Tuesday. And the climate does its part. Hot, dry summers bake west- and south-facing doors until the paint fades, the panels warp, and older wood carriage-style doors start rotting at the bottom rail. Add the dust that blows through the canyon neighborhoods, and by August a lot of Glendale garages have rollers and sensors that haven’t moved freely in months.
One more thing: Glendale has a deep Armenian and Persian homeowner community, and plenty of households here treat the garage as everyday living space – a guest room, a workshop, a place to entertain. That changes what people want from a door. They’re not asking for the cheapest builder panel. They want a quiet belt-drive opener, a well-insulated steel door, something that doesn’t rattle the house every time it cycles.
Styles & brands we work with
Our Main Glendale Services
Most calls we get in Glendale fall into two categories: a door that stopped working and an opener that’s acting up. Both are covered below, and each has its own dedicated Glendale page with full pricing and detail.
Garage Door Repair in Glendale
A broken spring or snapped cable leaves your door stuck – usually with your car on the wrong side of it. Glendale’s heat cycling puts extra stress on torsion springs, and in the hill neighborhoods a spring that gave out often took a cable or a bracket with it on the way. We carry the common sizes and brands on the truck, so most repairs are finished in one visit. Full details, pricing, and same-day notes are on our Garage Door Repair in Glendale page.
Garage Door Opener Repair in Glendale
Openers in Glendale work harder than most – sloped floors mean the motor fights gravity on every cycle, and dry canyon dust settles onto the rails and sensors. We diagnose brand-specific issues across LiftMaster, Chamberlain, Genie, and Craftsman units, from the most basic chain-drive to Wi-Fi-connected smart systems on the myQ and Aladdin Connect platforms. When the problem is board-level or gear-level, a repair often costs less than you’d expect. See Garage Door Opener Repair in Glendale for opener pricing and common failure signs.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Garage Door Installation in Glendale
Garage door installation in Glendale is rarely a clean swap of like-for-like. The older Spanish and Tudor homes often have single-car openings that were cut into the original structure decades ago, with header clearances that don’t meet modern track specs. The mid-century and ranch homes up the hill ZIPs have wider openings but sloped approach drives that change how the door sits when it cycles. And the summer sun is hard on whatever goes in – we spec doors with UV-stable finishes, reinforced panel cores, and hardware that won’t warp in a west-facing opening. That’s the difference between a door that works for two years and one that holds for twenty. Our full Garage Door Installation service covers everything from a single panel swap to a complete new door and opener package.
Garage Door Replacement
Signs you need it
Your door has multiple cracked or warped panels, the bottom section is rotting or rusted through, or the frame around the opening has shifted enough that the door no longer seals or balances.
What it costs in Glendale
Full garage door replacement in Glendale typically runs $700 – $2,200 depending on door size, material, insulation value, and how much custom fitting the opening needs.
How we do it
We measure the opening in place, verify the floor pitch and header condition, order the right door for the measurements (not the other way around), dismantle the old door, and install the new one with properly shimmed track and balanced springs.
Garage Door Installation Service
Signs you need it
You’ve built or framed a new garage, removed a wall to widen the opening, or bought a home with a doorless opening or an old door that was never properly installed.
What it costs in Glendale
New garage door installation in Glendale ranges from $700 – $2,200, with custom sizing, non-standard track, and smart opener integration at the upper end.
How we do it
We assess the rough opening, confirm clearances and ancho points, assemble the track system to match the floor pitch and headroom, hang and balance the door, then test the full cycle in both directions before we call it done.
Commercial Garage Door Installation
Signs you need it
Your Glendale commercial space or condo building has a heavy roll-up or sectional door that’s failed, worn out, or no longer meets current safety requirements for common-area use.
What it costs in Glendale
Commercial garage door installation in Glendale falls within our standard $700 – $2,200 range for most sectional models, with heavier roll-up systems priced by job walk after we see the opening.
How we do it
We coordinate access and schedule around your building’s use, spec the door for cycle count and thermal load, install with reinforced track and heavy-duty hardware, and test the safety reversal and photo-eye systems before final sign-off.
Garage Door Installation Contractors
Signs you need it
Your door was installed by a general contractor or handyman who didn’t specialize in garage doors, and now it binds, sags, scrapes, or won’t balance no matter how many times you adjust it.
What it costs in Glendale
Correcting or completing a botched install in Glendale usually lands in the $700 – $2,200 range, depending whether we can salvage the existing door or need to reorder components.
How we do it
We remove the poorly set track and hardware, re-measure the opening from scratch, correct the shimming and spring tension, and re-hang the door so it cycles clean without strain on the opener.
Garage Door Seal Installation
Signs you need it
You can see daylight under the door, water and dust blow in during winter rains and canyon wind, or the old rubber bottom seal has flattened, cracked, or pulled away from the retainer.
What it costs in Glendale
Garage door seal installation in Glendale is a smaller job, typically $110 – $220 for bottom seal replacement including the retainer and adjustment to keep the seal tight on a pitched floor.
How we do it
We remove the old seal and retainer, check the bottom of the door for rust or damage, install a fresh seal sized for the exact door thickness, and set it so it compresses evenly across the whole width of the opening.
What Garage Door Installation Costs in Glendale
| Item | Typical range in Glendale |
|---|---|
| New door installation | $700 – $2,200 |
| Panel replacement | $250 – $500 |
| Opener installation | $250 – $550 |
Do I need a permit to replace my garage door in Glendale?
For most like-for-like door replacements, no permit is required in Glendale – you’re swapping one door for another in the same opening. If you’re changing the opening size or the structural header above the door, the city may require plan check and a building permit through the Glendale Building & Safety division. We’ll tell you which applies before any work starts.
How long does a garage door install take in Glendale?
Most residential door replacements in Glendale are completed same-day, usually in four to six hours from arrival to final test. If we’re ordering a custom-sized door for a non-standard hillside opening, expect a one-to-two-week lead time for manufacturing, then a single-day install.
Brands We Service in Glendale
We work on the brand already on your garage. That means LiftMaster and Chamberlain openers we can diagnose without a manual, plus doors by Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor. Common rollers, sensors, circuit boards, and weather seal are stocked locally, so most Glendale repairs don’t wait on a parts order. See our brands for the full list of what we service.
See the difference
Before
After
Before
After
Before
AfterPricing for Garage Door Company in Glendale, CA
| Service | Typical range in Glendale |
|---|---|
| Spring repair | $180 – $340 |
| Cable repair | $130 – $250 |
| Opener repair | $120 – $320 |
| Roller replacement | $110 – $220 |
| Track realignment | $120 – $240 |
| Panel replacement | $250 – $500 |
| Opener installation | $250 – $550 |
| New door installation | $700 – $2,200 |
| Garage door repair | $150 – $600 |
In Glendale, prices climb when the home is on a slope that requires custom track shimming, when the opening is a non-standard width from an older bungalow, or when a hillside door has warped panels that need to be reordered rather than patched. Whatever the job, your price is quoted and agreed before any work starts – no surprises on the invoice.
Neighborhoods We Serve in Glendale
We cover all of Glendale, from the flatland bungalows to the canyon roads where driveways run steep. Most areas see us within a couple of hours on repair calls; installs are scheduled so the door arrives before the crew does.
- Adams Hill
- Chevy Chase Canyon
- Verdugo Woodlands
- Rossmoyne
- Glenoaks Canyon
Service Area – Cities Near Glendale
Our service area extends through the surrounding communities. We work regularly in Burbank, CA just west of Glendale, over into La Cañada Flintridge, CA to the north, and down into Echo Park, CA and Silver Lake, CA on the Los Angeles side.
Serving Glendale, CA — Our Local Coverage Area
We’re based in the Glendale area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Garage Door Company in Glendale
Most Glendale repair calls are answered the same day, with technicians typically arriving within two to three hours depending on where you are in the city. Canyon neighborhoods like Chevy Chase can add a few minutes of drive time, but we plan routes accordingly. Call (855) 740-8388 and we’ll give you a straight window.
Yes. Several Glendale neighborhoods have HOAs or design review boards with rules about door style, color, and material. We’ve installed doors that match the Spanish Colonial character of the older districts and the more contemporary look of the hill developments. If your HOA has a spec sheet, bring it to the estimate and we’ll quote to it.
Yes. We schedule installs Monday through Saturday, with morning and afternoon windows. If you need the door measured first and installed on a later date, we’ll handle the measurement visit and order the door so the install day itself is the only time you need to be home. Call (855) 740-8388 to set it up.
If your Glendale garage door needs work – a spring, a cable, an opener that’s grinding or a full replacement – call Stonewall at (855) 740-8388 for a free estimate. We’ll tell you what it needs, what it doesn’t, and what it’ll cost before anything starts.
What happens when you call
- 1A real person answersNo phone trees — talk to a local garage door pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Glendale Customers Say
"Opener works, remotes are programmed, no complaints on the work. Took three days to get on the schedule though, so if you've got a car trapped inside, say so when you call."
— Jeff Novak"Logic board on a 15 year old opener. He was upfront that a new opener would cost less than the board plus labor, and he wasn't wrong. No pressure either way."
— Kurt Sullivan"The old chain drive sounded like a freight train through the bedroom above the garage. Went with the belt drive they recommended and now I genuinely cannot hear it open from upstairs."
— Yolanda Herrera